Silentknight IP Communicator Modem Card Manuel d'utilisateur télécharger pdf (Page 1)

2UD Modem Card

Mounting Instructions

The mIP-2 and the IPDACT-2 products can be converted to a mIP-2UD or to an

IPDACT-2UD (respectively) by installing the 2UD Modem Card. This will provide full

Alarm Panel Upload/Download support over the IP network.

Figure 1. Adding the 2UD modem card to a mIP-2 or an IPDACT-2 module

WARNING! Before proceeding with the installation, make sure all power

(AC and DC) has been removed.

The installer should follow the steps described below:

1. Remove the plastic label/cover from the IPDACT-2 Module. If the module is a mIP-2

this step may not be required.

2. Remove the jumpers from A and B pins located in the upper left portion of the mIP-2

or the IPDACT-2 module.

Dm395-Iv1 1

1 2

2UD Modem Card Mounting Instructions The mIP-2 and the IPDACT-2 products can be converted to a mIP-2UD or to an IPDACT-2UD (respectively) by install

Page 2

Figure 2. Close-up of pins A and B in mIP-2 and IPDACT-2 modules 3. Carefully align the connector on the 2UD Modem Card with the connector located

Pas de commentaire

Silentknight IP Communicator Modem Card Manuel d'utilisateur Page 1