Silentknight 5280 Status Display Module for 5208 Manuel d'utilisateur télécharger pdf

P/N 151238

SK-5280 Status Display

Module Installation

Instructions

The following instructions are a quick reference guide, refer to

the control panel installation manual for detailed system

information.

The SK-5280 Status Display module provides outputs and

control functions for remote annunciation of alarm, trouble, and

supervisories for each zone.

Note: The driver outputs are non-supervised.

Figure 1: Model 5280 Board Layout

The SK-5280 has 1 connector which has 10 outputs for alarms

and 10 outputs for trouble annunciation. These outputs are active

low. Each output can provide up to 100 mA of current, with a

total limitation of 700 mA. The module has 4 normally open non-

dedicated relays that can be wired to be active with any of the

outputs. The system can supervise up to 8 5280 Status Display

Modules.

Wire the SK-5280 as shown in Figure 2. Maintain a physical

separation of one-half inch or more between field wires and

connection points to prevent damage from transients.

Note: SILENCE does not affect SK-5280 outputs. To reset a SK-

5280 output, the alarm or trouble condition must be

restored.

The SK-5280 can be used to interface to LED annunciator.

The SK-5280 can be programmed to indicate alarms and trouble

status for; zones 1 - 10, zones 11 - 20, zones 21 - 30, or system

status outputs.

Figure 2: SK-5280 Connection to the Control Panel

Mounting the 5280

The SK-5280 mounts onto a metal bracket and standoffs in the

SK-5208 cabinet or into SK-2190 accessory cabinet.

Mounting the SK-5280 into

SK-5208 Cabinet

Follow these steps to properly mount the SK-5280 into the

SK-5208 cabinet:

1. Remove power from the control panel.

2. Mount the SK-5280 onto the standoffs and bracket located

in the cabinet. See Figure 3.

Figure 3: Installing the 5280 Into the 5208 Cabinet

3. Connect the SK-5280 to the SK-5208 control panel as

shown in Figure 2.

4. Set the ID number. See the 5208 Installation Manual (PN

151204) for information on setting ID numbers.

5. Reconnect power to the control panel.

Trouble Outputs

ID Number

DIP Switch

SBUS Connector

4 On-board Relays

Regulated Alarm

Outputs

1/4” spacing must be maintained between

all power limited & non-power limited wiring

Relays are non-power

limited

SBUS is power limited

Control

Panel

5280

Supervised

Power Limited

1 2

Résumé du contenu

Page 1 - Instructions

P/N 151238 SK-5280 Status Display Module Installation InstructionsThe following instructions are a quick reference guide, refer to the control panel i

Page 2 - Specifications

SK-5280 Status Display Module Installation Instructions2 151238 Rev CMounting the SK-5280 into the SK-2190 Accessory CabinetFollow these steps to prop

Commentaires sur ces manuels

Pas de commentaire

Silentknight 5280 Status Display Module for 5208 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sécurité Silentknight 5280 Status Display Module for 5208. SilentKnight 5280 Status Display Module for 5208 User Manual [it] [en] [de] [es] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Silentknight 5280 Status Display Module for 5208