Silentknight VisorAlarm Plus 2U Operating Instructions Manuel d'utilisateur télécharger pdf (Page 14)

VisorALARM PLUS 2U Operating

III - 7

Doc.DM375-I

Ver.1.0

2. Operating in manual mode

When the VisorALARM PLUS 2U receiver has no Automation Software connected or the Automation

Software has failed, the receiver must be operated in manual mode.

In manual mode signals must be visualized and acknowledged from the receiver through the receiver

LCD and keypad.

When a signal arrives at the receiver in manual mode, the LCD shows a status line as follows:

If you are not logged into the VisorALARM PLUS 2U receiver when events are received pressing the

ACK key for the first time will display the highest priority event and silence the receiver piezo. If the

ACK key is pressed a second time you will be prompted for a password. Upon entering the password

the event with the highest priority is resounded. Repeatedly pressing the ACK key will now display

and acknowledge subsequent events.

Subsequently the signal information is shown in the display with the next format:

The LCD shows the following information:

§ hh:mm:ss: The hour, minutes and seconds of the alarm in a 24 hours format

§ aaaaaaaa: The eight digit account code

§ Q: Qualificator, E= New event or opening; R=Restoration or closing; P=Status report.

§ XYZ: Event code

§ GG: Number or group or partition.

§ CCC: Zone number or user identifier.

§ TTTTTTT: Textual description for the event code. This contemplates the following values:

Event Code

TTTTTTT

10x Medical

11x Fire

12x Panic

13x Burglar

14x, …, 1Fx

Alarm

2xx Superv

3xx Trouble

4xx Opn/Cls

hh:mm:ss aaaaaaaa »

QXYZ GG CCC TTTTTTTTT

16:33:23 00001234 »

E110 01 001 Fire

PRIMARY VisorALARM

1 Signal pending

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Silentknight VisorAlarm Plus 2U Operating Instructions Manuel d'utilisateur Page 14